Minibeast Cordless
This document is protected by copyrights.
Copying, using, or distributing without permission of JEI Drilling & Cutting Solutions is prohibited.
10
4. STARTUP AND OPERATION
4.1. Tools compatible with drilling machine
The drilling machine can be used with tools listed in the following table.
Tool
Maximum tool
diameter
Application
Tool holder
Turbo Tough, TCT
annular cutter
36 mm
(1.42″)
Drilling through holes
19 mm (3/4
″
)
Weldon
Turbo Steel, HSS
annular cutter
30 mm (1.18
″
)
Turbo Steel, Twist drill
bit
12 mm (0.47
″
)
Drilling through and
blind holes
Turbo Steel, Countersink
30 mm (1.18
″
)
Countersinking and
chamfering holes
4.2. Installing and removing the tool
Remove the battery. Lift the chip guard (1). Turn the handles to the right (2) to lift the
motor. When you install the annular cutter
– use gloves to put the correct pilot pin into
the cutter (3). Use a dry cloth to clean the spindle and the tool. Put the tool into the
spindle (4) so that the flat surfaces (5) align with the screws (6). Use the 4 mm hex
wrench to tighten the screws. To remove the tool, loosen the screws.
