JEI GroupLtd
AIRBEAST 35 ATEX
AIRBEAST 35
ATEX Operator’s Manual
7
3. STARTUP AND OPERATION
3.1. Mounting and operation of annular cutter
With the machine unplugged from the supply, proceed as follows. Maximally raise the
chip guard (
1
, Figure 2) and rotate the feed lever counterclockwise (
2
) to access the
set screws
3
.
Then, insert
the proper pilot pin into the annular cutter (
4
), after which
wear protective gloves and place
the
cutter
into
the
arbor
(
5
)
in
such
a
way to align the
flats
6
with the set screws
3
.
Finally,
tighten
both
set screws with 4 mm hex wrench. To
dismount the cutter, proceed in reverse order.
All safety precautions must be closely observed.
