BM-7
This document is protected by copyrights.
Copying, using, or distributing without permission of JEI GROUP LTD is prohibited.
13
3.5. Operating
Install the required milling head with cutting inserts, and set the required bevel width.
Next, connect the machine to the power source, and place the machine on the left so
that the milling head is not in contact with the workpiece (Fig. 7). The workpiece must
be stable and well fixed.
Fig. 7.
Machine properly placed on a plate
Press and hold
the
ON/OFF
switch
to
start
the
motor
and
wait
a few seconds until
the machine reaches the maximum rotational speed. Next, press the machine to the
workpiece with both hands, slowly slide the machine toward the edge, and then slide
the machine according to the counter-rotation, that is from left to right.
Bevel in two passes. The bevel width should be set to a value that will allow the
feed of one meter per minute without significant effort.
Replace inserts before they become dull to prevent the motor from overloading.
Additionally,
take
periodic
breaks
during
operation to prevent the motor from
overheating and damaging the windings.
After the work is finished, release the ON/OFF switch to turn off the motor, wait
until the rotation stops, and unplug the machine from the power source.
Clean
the
machine
with a cotton cloth without using any agents.
Feed direction
ON/OFF switch
Start the machine and
slide toward
