ABM-28
ABM-28
Operator’s Manual
9
3. STARTUP AND OPERATION
3.1. Installation
The carriage set on the guide in utmost left position must be placed on a plate
between two clamps in the manner shown in Figure 3a. If needed, extend the guide
length by connecting additional guide segments and tighten the set screws using
4 mm hex wrench (Figure 3b). Then, mount the protective bolts
1
and
2
at both ends
of the guide, and position the guide using track clamps in a way to align the track
clamps with respective surfaces of the guide and plate. Mount the track clamps using
levers (
3
,
4
,
5
) and tighten the clamp screws by rotating the clamping rods (
6
,
7
). To
adjust
pressing force of track clamps depending on plate thickness, use adjusting
screws which can be located in one of three holes.
Figure 3.
Placing machine on plate (a); mounting additional guide segments (b)
WARNING! Read safety precautions before starting.
5
3
7
6
b)
a)
4
1
2
set screw
10
8
9