background image

 

 

 

 

 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 

IMPORTANT NOTES 
 

1. Maintenance: For best operation and reception, periodically clean mast (while fully extended) with a damp cloth, 
approximately once a month. Do not oil or grease antenna or motor assembly. 
 
2. Power antenna is designed to withstand extremely cold temperatures, but under severe icing conditions, the antenna 
could fail to extend or retract. Should this occur, turn the radio on and off three or four times to help free the antenna 
mast. The antenna motor will not be damaged if mast does not extend. A special clutch protects the motor from 
possible damage. 
 
3. Remember to retract antenna when entering a car wash, garages or low clearance areas. 
 
4. There are no serviceable parts in the motor assembly and it should not be taken apart. Warranty will be invalid if 
damage is caused by unauthorized accessories, disassembly or for wiring methods other than those recommended. 
 
5. Periodically inspect drain tube for blockage or kinks. 
 
6. Use a 5 amp fuse in case of replacement to avoid damage to the motor.

 

                                         1-800-345-4545   jegs.com

 

Summary of Contents for 89504

Page 1: ...ION For first time antenna installations A Use original factory hole or select a location on the front or back fender of car for mounting antenna In selecting the location make sure the underside of the fender is free of any obstruction such as weld beads braces gussets and sub fender Also be sure that sufficient clearance is available under fender to house the antenna approximately 11 1 2 29cm B ...

Page 2: ... may strip or break the mounting threads or damage contact spring and cause improper antenna operation I Attach the drain lube to the bottom of the motor assembly and route to the outside of the car Avoid any kinks or bends in the tube that may restrict drainage as shown in figure 1 For new antenna installations J Route electrical wiring and coaxial cable into the dash area of the vehicle interior...

Page 3: ...nd contact spring Save and clean contact spring for re use Note which side of antenna serrated cable is facing FIG B C Insert serrated cable of new mast into the housing Stop when resistance is felt approximately 12 30mm The serrated side of cable must duplicate original direction D Turn radio switch off to lower antenna until serrated cable catches It may be necessary to cycle antenna several tim...

Page 4: ...s to help free the antenna mast The antenna motor will not be damaged if mast does not extend A special clutch protects the motor from possible damage 3 Remember to retract antenna when entering a car wash garages or low clearance areas 4 There are no serviceable parts in the motor assembly and it should not be taken apart Warranty will be invalid if damage is caused by unauthorized accessories di...

Reviews: