5.2 USING THE USB PORT
The USB port provides up to 2.4A at 5V DC.
1. Ensure the battery clamps are securely clipped on the storage holders.
2. Flip the ON/OFF power switch to turn the unit ON.
3. Plug your device into the USB port.
4. Turn on the USB device.
5. When finished using the USB port, flip the switch to the OFF position.
6. Recharge the unit as soon as possible after each use.
5.3 USING THE WORK LIGHT
1. Position the jump starter on a flat, stable surface near the intended work area.
2. Ensure the battery clamps are securely clipped on the storage holders.
3. Flip the ON/OFF power switch to the ON position.
4. Press the Battery Status/Light button on the front of the unit for 0.75 second, to turn on the work light.
5. When finished using the work light, press the button for 0.75 second, to turn off the work light.
6. Recharge the unit as soon as possible after each use.
5.4 USING THE AIR COMPRESSOR
WARNING
Read the instructions of the product being inflated before using the compressor. Avoid over inflation; do
not exceed the manufacturer’s recommended pressures. Do not leave the air compressor unattended during use.
1. Remove the air compressor hose from the storage cleats.
2. Connect the adapter to the valve stem by threading it onto the end. If necessary, use one of the additional
adapters.
3. Turn ON the compressor power switch and inflate to the desired pressure or fullness.
NOTE
: To prevent overheating, the compressor has built-in thermal protection that will turn the compressor off before it
overheats. If the compressor shuts off, wait a few minutes and it will automatically restart when the compressor cools.
4. When the desired pressure is reached, move the compressor power switch to OFF and unthread the connector
from the valve stem.
5. Wrap the compressor hose around these cleats when it is not being used.
ESTIMATED TIME FOR INFLATING
Vehicle tires 13-16"
6-24 minutes
Bike tires
1-3 minutes
Sports balls
30 seconds
6. Allow unit to cool.
7. Recharge the unit before storing.
NOTE
: The air compressor is rated for 150 PSI.
5.5 ENERGY SAVING MODE
If the unit is not used after the ON/OFF power switch is turned on, the unit will go into Energy Saving mode after 10
minutes to prevent battery discharge. Follow these steps to use any function after Energy Saving mode:
1. Press the ON/OFF power switch to turn the unit ON.
2. The Green Ready/Fail LED will light.
3. After 10 minutes, The USB port and Battery Status/Light function will turn off.
4. After 10 minutes, The Green Ready/Fail LED will turn off.
5. Press the Battery Status/Light button once. The unit is now ready for checking the battery status and using the jump
starter, compressor, USB and work light.
1-800-345-4545 jegs.com
