Charger Operation
Before using your tool for the first time, the battery should be fully charged. If the battery
pack is installed in the tool, remove it following the charging procedure below.
Charging Procedure
Make sure power circuit voltage is the same as the shown on the charger specification.
1.
Plug the charger into outlet before inserting battery pack.
2.
Insert battery pack into charger. Indicator light on charger changes to show the charging
process
Battery is charging (Solid Red)
The charging is complete (Solid Green)
Red light flashing at a fast rate, replace battery
Charger detected a weak or damaged battery
Stop charging battery.
3.
Disconnect charger from power source and remove battery pack from charger after full
charged.
CAUTION!
Charge the battery in clean and dry location when temperatures are between 10℃ to 40℃.
Battery temperature will increase during and shortly after use. Battery may not accept a
full charge if charged immediately after use. Allow the battery pack to cool to room
temperature before charging for best charging.
Important note:
When battery pack is fully charged, disconnect the charger from the
power source and remove the battery pack from the charger
1-800-345-4545 jegs.com
Summary of Contents for 81026
Page 9: ...1 800 345 4545 jegs com ...
