6
USER MANUAL
JEFHTG2S-230
2000W HEAT GUN
www.jeffersontools.com
Power tool use and care
•
Do not force the power tool. Use the correct power tool for your application. The correct power tool will do the job better and
safer at the rate of which it was designed.
•
Do not use the power tool if the switch does not turn it on and off. Any power tool that cannot be controlled with the switch is
dangerous and must be repaired.
•
Disconnect the plug from the power source before making any adjustments, changing accessories, or storing power tools.
Such preventive safety measures reduce the risk of starting the power tool accidentally.
•
Store idle power tool out of the reach children and do not allow persons unfamiliar with the power tool of these instructions to
operate the power tool. Power tools are dangerous in the hands of untrained users.
•
Maintain power tools. Check for misalignment or sticking of moving parts, breakage of parts and other condition that may
affect the power tool’s operation. If damaged, have the power tool repaired before use. Many accidents are caused by poorly
maintained power tools.
•
Keep cutting tools sharp and clean. Properly maintained cutting tools with cutting edges are less likely to stick and are easier
to control.
•
Use the power tool, accessories and tool bits etc., in accordance with these instructions and in the manner intended for the
particular type of power tool, taking into account the working conditions and the work to be performed. Use of the power tool
for operations different from intended could lead to a hazardous situation.
Servicing
Have your power tool serviced as required by a qualified repair person if replacement parts are required repair using only Jefferson
approved components. Contact your nearest Jefferson Dealer for further information.
Additional Safety Instructions For Heat Guns
•
Do not place your hand over the air vents or block the vents in any way.
•
The nozzle and accessories of this tool become extremely hot during use. Let these parts cool down before touching.
•
Always switch the tool off before putting it down.
•
Do not leave the tool unattended while it is switched on.
•
A fire may arise if the appliance is not used with care.
•
Heat may be conducted to combustible materials that are out of sight. Do not use in a damp atmosphere, where flammable
gases may be present or near combustible materials.
•
Allow the tool to cool fully before storing.
•
Ensure adequate ventilation as toxic fumes may be produced.
•
Do not use as a hairdryer.
•
Do not obstruct either the air intake or nozzle outlet, as this may cause excessive heat build up resulting in damage
•
Do not direct the hot air blast at other people.
•
Do not touch the metal nozzle as it becomes very hot during use and remains hot for up to 30 minutes after use.
•
Do not place the nozzle against anything while using or immediately after use.
•
Do not poke anything down the nozzle as it could give you an electric shock. Do not look down the nozzle while the unit is
working because of the high temperature being produced.
•
Do not allow paint to adhere to the nozzle or scraper as it could ignite after some time.
