PAGE 1
Copyright JEFA Tech, Inc. - All rights reserved - http://www.jefatech.com
JEFA TECH REPEATER XR PLUS
CONFIGURATION
INSTRUCTIONS
THANK YOU FOR PURCHASING A JEFA TECH REPEATER XR PLUS!
How the JEFA TECH REPEATER XR PLUS System Works
The JEFA Tech Repeater XR PLUS consists of two main components:
BULLET Outdoor WiFi Bridge and fiberglass antenna. It receives the signal from the
source WiFi. The antenna must be placed outside in a vertical position with the antenna
pointing straight up. Place it where it has a clear line of sight to the source WiFi.
AIRGATEWAY Indoor Access Point – this is the black device with black antenna. It
should be placed inside in a convenient location. It broadcasts a private WiFi signal that
you will connect your devices to. You can connect any WiFi device to the
AIRGATEWAY including laptops, tablets, printers, gaming consoles, or video streaming
devices.
IMPORTANT:
DO NOT PRESS RESET BUTTONS ON ANY OF THE EQUIPMENT
Doing so will put the system in a default state that will require technical support to fix.
ABOUT CONFIGURING YOUR DEVICES:
The BULLET outside antenna and AIRGATEWAY are configured independently of each other.
The following IP addresses are associated with each of the devices:
BULLET - outside antenna / WiFi receiver – used for scanning for the WiFi network to repeat:
http://192.168.123.1
AIRGATEWAY – indoor access point – used for broadcasting your private WiFi network:
http://192.168.123.2
Their interfaces look almost identical so it is important to keep track of which device you are
configuring. 99% of the time you will be using
http://192.168.123.1
only
