Jeep Wrangler2018, Owner'S Manual

Page: 70 / 608

Intermittent Wiper System
Use the intermittent wiper when weather conditions make
a single wiping cycle, with a variable pause between cycles,
desirable. Rotate the end of the lever to the first detent
position for one of four intermittent settings. The delay
cycle can be set anywhere between 1 to 18 seconds.
NOTE: The wiper delay times depend on vehicle speed. If
the vehicle is moving less than 10 mph (16 km/h), delay
times will be doubled.
Windshield Washers
To use the washer, pull the lever toward you and hold
while spray is desired. If the lever is pulled while in the
delay range, the wiper will start and continue to operate
for two or three wipe cycles after the lever is released.
Then, the intermittent interval previously selected will
resume.
If the lever is pulled while in the off position, the wipers
will operate for two or three wipe cycles. Then, the wipers
will turn off.
WARNING!
Sudden loss of visibility through the windshield could
lead to a collision. You might not see other vehicles or
other obstacles. To avoid sudden icing of the wind-
shield during freezing weather, warm the windshield
with the defroster before and during windshield
washer use.
Mist Feature
Pull up on the wiper lever to activate a single wipe to clear
off road mist or spray from a passing vehicle. As long as the
lever is held up, the wipers will continue to operate.
Front Wiper Control
68 GETTING TO KNOW YOUR VEHICLE