Jeep Wrangler2018, Owner'S Manual, Page: 54 / 608

Using The Retention Straps
1. There are two retention straps located on the back of the
rear seat and two corresponding wire loops located on
the back of each b-pillar. Open the velcro on the strap
and thread through the wire loop. Fold the velcro over
to keep the seat in the folded position. This should be
done on both sides.
2. To return the seat to its normal upright position, reverse
these steps.
Removing The Rear Seat
1. Push down on the release bar on each side, and pull the
seat out and away from the lower bracket.
2. Remove the seat from the vehicle.
3. To reinstall the rear seat, just reverse these steps.
NOTE: Do not drive the vehicle without reattaching the
rear seat latches.
Rear Seat Tumble Position Retention Strap
Release Bar Location
52 GETTING TO KNOW YOUR VEHICLE