Jeep Wrangler 2011, User Manual

Page: 51 / 88

COMMAND-TRAC
®
/
ROCK-TRAC
®
• The transfer case provides four mode
positions: 2H (Two-wheel drive high
range), 4H (Four-wheel drive high
range), N (Neutral), and 4L
(Four-wheel drive low range).
• The transfer case is intended to be
driven in the 2H position for normal
street and highway conditions such
as hard-surfaced roads.
• Shifting between 2H and 4H can be
made with the vehicle stopped or in
motion. Shift the transfer case lever
firmly to 4H at any speed up to
50 mph (80 km/h).
• Shifting between 4H and 4L can be
made with the vehicle rolling at 2 to
3 mph (3 to 5 km/h). Shift the
automatic transmission into
NEUTRAL or fully depress the clutch
pedal on a manual transmission. Shift
the transfer case lever firmly to 4L (do
not pause with the transfer case in
NEUTRAL). Once the shift is
completed, place the automatic
transmission into DRIVE or release
the clutch pedal on a manual
transmission.
NOTE: To enhance off-road performance
in 4L mode, manual transmission vehicles
will start regardless of whether or not the
clutch pedal is depressed.
AXLE LOCK (TRU-LOK
®
)
RUBICON ONLY
• The AXLE LOCK switch is located on
the instrument panel (to the left of the
steering column).
• This feature will only activate when
the following conditions are met:
• Key in ignition, vehicle in 4L (Low)
range.
• Vehicle speed at 10 mph (16 km/h)
or less.
• Press the bottom of the AXLE LOCK
switch once to lock the rear axle only
and a second time to lock the front
axle (the rear and front axle lock
indicator lights will illuminate).
• To unlock the axles, press the top of
the AXLE LOCK switch.
• The indicator light will flash until the
axles are fully locked or unlocked.
ELECTRONIC SWAY BAR
DISCONNECT – RUBICON
ONLY
Off-Road
• Press the SWAY BAR switch, located
on the instrument panel (to the left of
the steering column), once to
disconnect the Sway Bar.
• The Sway Bar indicator light will
illuminate in the instrument cluster.
On-Road
• Press the SWAY BAR switch a
second time to reconnect the Sway
Bar.
• The Sway Bar should remain in
on-road mode during normal driving
conditions.
OFF-ROAD CAPABILITIES
49