Jeep GLADIATOR 2022, Owner'S Manual

Page: 53 / 380

NOTE:
The engine must be running before the headlights will
come on in the automatic mode.
LIGHTS-ON REMINDER
If the headlights or parking lights are left on after the
ignition is placed in the OFF position, the vehicle will
chime when the driver’s door is opened.
FRONT FOG LIGHTS — IF EQUIPPED
The Front Fog Lights are located on the front of the
vehicle below the headlights. When activated, these
lights add illumination directed at the driving surface to
aid in poor visibility conditions.
To activate the Front Fog Lights, turn on the parking
lights or low beam headlights and push the fog light
switch. Pushing the fog light switch a second time will
turn the front fog lights off.
TURN SIGNALS
Move the multifunction lever up or down to activate the
turn signals. The arrows on each side of the instrument
cluster flash to show proper operation.
NOTE:
If either light remains on and does not flash, or there is
a very fast flash rate, check for a defective outside light
bulb.
LANE CHANGE ASSIST —
IF EQUIPPED
Lightly push the multifunction lever up or down, without
moving beyond the detent, and the turn signal will flash
three times then automatically turn off.
BED LIGHTS — IF EQUIPPED
The bed lights will illuminate the bed and cargo area.
Bed lights are turned on by pushing the bed light switch
located on the lower half of the headlight switch.
A telltale will illuminate in the instrument cluster display
when these lights are on. Pushing the switch a second
time will turn the lights off.
The bed lights will turn on for approximately 60 seconds
when a key fob unlock button is pushed, as part of the
Illuminated Entry feature.
Front Fog Light Switch
Front Fog Light Switch (Vehicles Sold In Canada) Bed Light Switch
Bed Light Switch (Vehicles Sold In Canada)
GETTING TO KNOW YOUR VEHICLE 51
2