Programming And Requesting
Additional Key Fobs
Programming the key fob may be performed by an
authorized dealer.
NOTE:
•
Once a key fob is programmed to a vehicle, it cannot
be repurposed and reprogrammed to another
vehicle.
•
Only key fobs that are programmed to the vehicle
electronics can be used to start and operate the
vehicle. Once a key fob is programmed to a vehicle,
it cannot be programmed to any other vehicle.
WARNING!
•
Always remove the key fobs from the vehicle and
lock all doors when leaving the vehicle
unattended.
•
Always remember to place the Keyless Enter ‘n
Go™ Ignition in the OFF position.
Duplication of key fobs may be performed at an autho-
rized dealer. This procedure consists of programming a
blank key fob to the vehicle electronics. A blank key fob
is one that has never been programmed.
NOTE:
•
When having the Sentry Key Immobilizer system
serviced, bring all vehicle keys with you to an autho-
rized dealer.
•
Keys must be ordered to the correct key cut to
match the vehicle locks.
SENTRY KEY
The Sentry Key Immobilizer system prevents unauthor-
ized vehicle operation by disabling the engine. The sys-
tem does not need to be armed or activated. Operation
is automatic, regardless of whether the vehicle is
locked or unlocked.
The system uses a key fob, keyless push button ignition
and a Radio Frequency (RF) receiver to prevent unau-
thorized vehicle operation. Therefore, only key fobs that
are programmed to the vehicle can be used to start and
operate the vehicle. The system cannot reprogram a
key fob obtained from another vehicle.
After placing the ignition switch in the ON/RUN position,
the Vehicle Security Light will turn on for three seconds
for a bulb check. If the light remains on after the bulb
check, it indicates that there is a problem with the elec-
tronics. In addition, if the light begins to flash after the
bulb check, it indicates that someone attempted to
start the engine with an invalid key fob. In the event
that a valid key fob is used to start the engine but there
is an issue with the vehicle electronics, the engine will
start and shut off after two seconds.
If the Vehicle Security Light turns on during normal
vehicle operation (vehicle running for longer than ten
seconds), it indicates that there is a fault in the elec-
tronics. Should this occur, have the vehicle serviced as
soon as possible by an authorized dealer.
CAUTION!
The Sentry Key Immobilizer system is not compatible
with some aftermarket remote starting systems. Use
of these systems may result in vehicle starting prob-
lems and loss of security protection.
All of the key fobs provided with your new vehicle have
been programmed to the vehicle electronics
IGNITION SWITCH
KEYLESS ENTER ‘N GO™ IGNITION
This feature allows the driver to operate the ignition
switch with the push of a START/STOP ignition button
as long as the key fob is in the passenger
compartment.
The START/STOP ignition button has several operating
modes that are labeled and will illuminate when in posi-
tion. These modes are OFF, ACC, RUN, and START.
START/STOP Ignition Button
1 — OFF
2 — ACC
3 — RUN
GETTING TO KNOW YOUR VEHICLE
17
2
Summary of Contents for GLADIATOR 2022
