Jeep Compass, Quick Manual To Repairs, Page: 33 / 38

Jeep Compass
Towing/lifting the vehicle
Rear towing attachment
The rear towing attachment is located behind a flap behind a flap on
the rear right side of the bumper.
To fit the attachment, open the flap using the car key or a small
screwdriver, then tighten the attachment in its housing.
Insert the flat part of the jack lever in the towing attachment and
tighten. The towing attachment must be completely inserted in the
respective fastening bracket through the lower part of the rear
bumper. Do not tow the car if the towing attachment is not
completely inserted in the fixing bracket.
Position of the rear towing attachment
5.3 LIFTING THE CAR
If the vehicle needs to be lifted, use a suitable 2-post car lift or
workshop jack.
IMPORTANT!
Do not place the lifting device on any suspension component, front
or rear suspension crossmember included (3). Do not lift the vehicle
from the front and rear bumper, the lower radiator crossmember or
the front engine mounting. Do not try to completely lift the vehicle on
one side by only placing a floor jack between the front and rear
wheels. This may damage the vehicle permanently.
IMPORTANT!
Because of the different design of the lifting systems, secondary
lifting points to avoid damaging the body or the trim.