Jeep Compass 2010, User Manual

Page: 35 / 76

• To reset all resettable functions, press and release the EVIC button a second time within
three seconds of resetting the currently displayed function. Reset ALL will be displayed
during this three-second window.
UNIVERSAL GARAGE DOOR OPENER (HomeLink
®
)
Programming HomeLink
®
Begin Programming
• The HomeLink
®
buttons are located in the
headliner.
• Erase all channels before you begin
programming by holding the two outside
buttons for up to 20 seconds until the red
indicator flashes.
• Park your vehicle outside of the garage and turn the ignition switch to the ON/RUN
position.
• Place the handheld transmitter 1 to 3 in (3 to 8 cm) from the HomeLink
®
buttons while
keeping the indicator light in view.
• Simultaneously, press and hold both the chosen HomeLink
®
button and the handheld
transmitter button until the HomeLink
®
indicator flash rate changes from a slow to a
rapidly blinking light, then release both the HomeLink
®
and the handheld transmitter
buttons. This may take up to 30 seconds, or longer in rare cases.
• Press and hold the just-programmed HomeLink
®
button; if the indicator light stays on
constantly, programming is complete and the garage door should open.
WARNING!
• Your motorized door or gate will open and close while you are programming the
universal transceiver. Do not program the transceiver if people or pets are in the
path of the door or gate. Only use this transceiver with a garage door opener that
has a “stop and reverse” feature as required by Federal safety standards. This
includes most garage door opener models manufactured after 1982. Do not use a
garage door opener without these safety features. Call toll-free 1–800–355–3515
or, on the Internet, at www.HomeLink.com for safety information or assistance.
• Do not run your vehicle in a closed garage or confined area while programming
the transceiver. Exhaust gas from your vehicle contains Carbon Monoxide (CO)
which is odorless and colorless. Carbon Monoxide is poisonous and can cause
serious injury or death when inhaled.
NOTE:
If you are having difficulty programming your HomeLink
®
and your garage door
opener was manufactured after 1995, you may have a rolling code. Follow the steps below
for Programming A Rolling Code System.
33
ELECTRONICS