Jeep 2011 grand cherokee, User Manual

Page: 58 / 108

NOTE: The power inverter is designed with built-in overload protection. If the
power rating of 150 Watts is exceeded, the power inverter will automatically shut
down. Once the electrical device has been removed from the outlet, the inverter
should automatically reset. If the power rating exceeds approximately 170 Watts,
the power inverter may have to be reset manually. To reset the inverter manually,
unplug the device and plug it in again. To avoid overloading the circuit, check the
power ratings on electrical devices prior to using the inverter.
WARNING!
To Avoid Serious Injury or Death: Do not use a three-prong adaptor. Do not insert
any objects into the receptacles. Do not touch with wet hands. Close the lid
when not in use. If this outlet is mishandled, it may cause an electric shock and
failure.
POWER OUTLET
• The front power outlet is located
inside the center storage bin of the
instrument panel. Push inward on the
storage lid to open the compartment
and gain access to this power outlet.
• A second front power outlet is
located inside the center console.
• The rear power outlet is located in
the right rear cargo area.
• The power outlets are labeled with either a “key” or a “battery” symbol to
indicate how the outlet is powered. Power outlets labeled with a “key” are
powered when the ignition switch is in the ON/RUN or ACC position, while the
outlets labeled with a “battery” are connected directly to the battery and
powered at all times.
NOTE:
• Do not exceed the maximum power of 160 Watts (13 Amps) at 12 Volts. If the
160 Watt (13 Amp) power rating is exceeded, the fuse protecting the system will
need to be replaced.
• All accessories connected to the “battery” powered outlets should be removed or
turned off when the vehicle is not in use to protect the battery against discharge.
ELECTRONICS
56