![background image](http://html1.mh-extra.com/html/jeanneau/merry-fisher-705/merry-fisher-705_owners-manual_3622349083.webp)
79/86
LAUNCHING RECOMMENDATIONS
A lot of skill and care is required to commission your JEANNEAU boat. The proper
working of all your boat's equipment is the result of the quality of the commissioning
operations.
In order to remain completely under guarantee in the case of any failure of parts or
materials the first launching and the first trials of different equipment must be carried out
by your JEANNEAU dealer.
If later you have to launch your boat yourself, you should take the following precautions:
BEFORE LAUNCHING
- If your boat is to be fitted with sounder and speedometer, allow for the relevant fittings
and their installation.
- Check the water intake strain box for cleanliness.
- Check the engine and reduction gear oil levels (refer to engine manual).
- Turn off the engine cooling water drain valves.
- Retract the speedometer into its housing (it may be damaged by the handling belts).
- For the on-line engines, check the anode at the end of the shaft is in place. Check the
nut tightening (the lock washer shall be turned over onto the nut). The anode shall not
be painted.
- Turn off all the water inlet and drain valves (sink, washbasin, heads, engine).
11
L
A
U
N
C
H
IN
G
Summary of Contents for MERRY FISHER 705
