Jeanneau CAP CAMARAT 925 WA, Owner'S Manual

Page: 55 / 86

51/82
084807
Index H
USE OF MARINE HEADS EQUIPPED WITH A WASTE HOLDING TANK (WHT) -
OPTIONAL EQUIPMENT
There are two different types of WHT: The simple tanks (Fig. 1) and the tanks equipped
with 3 way valves (Fig. 2).
Open the water intake valve (ref. 1) (valve handle parallel to the pipe).
In the case of a direct discharge into the sea:
- Fig. 1: Open the draining valve (ref. 2).
- Fig. 2: Close the access to the tank with the 3 way valve (ref. 6). Open the draining
valve (ref. 7).
In case you store the waste waters in the tank:
- Fig. 1: Make sure the draining valve is closed (ref. 2) (valve handle perpendicular to
the pipe).
- Fig. 2: Make sure the draining valves are closed (ref. 2, 7) (valve handle perpendicular
to the pipe). Open the access to the tank with the 3 way valve (ref. 6).
To drain the bowl, set the control lever of the pump slantwise (FLUSH) then operate the
pump.
To dry the bowl, set the lever vertical (DRY) then operate the pump.
In order to avoid clogging the heads:
- Use absorbent paper exclusively.
- Schedule a regular rinsing through of the system with fresh water.
WARNING
Ask for information about the laws in force in your country or your marina about
discharging your waste waters into the sea.
PRECAUTION
Close the valves after each use and above all when the boat is unattended.
WARNING
The tanks' nominal capacity cannot be fully used due to the load and the need to
maintain the correct trim. A 20% reserve should be kept.
6
P
L
U
M
B
IN
G