SETUP
8
1) Connect 12vdc power and RS-485 network pair (B+, A-) to the keypad(s).
(NOTE: Some Stargate RS-485 connectors are labeled "TRB" instead of B+ and "TRA" instead of A-)
If an external 12vdc power supply is used, you MUST connect the ground (negative) of the power supply to the ground (-) terminal
of Stargate. The 3 LEDs will blink for several seconds as Stargate establishes communication with the keypad.
2) After the LEDs stop blinking, press and hold the top button (either side) until the Setup menu screen appears (about 6 seconds).
NOTE: Setup can only be accessed from the Main Menu (Menu #1) top button.
3) If the screen appears blank or faint, using a small screwdriver, slowly turn the tiny screen contrast control ("POT1") near the
RS-485 connector on the back of the keypad (see page 4).
4) Set the keypad address to a number from 1 to 16 using the #2 button labeled "Addr". Press the right side of the button to
increment or the left side to decrement. NOTE: Each LCD-96M must be set to a different address number.
5) Set the default menu screen number (menu screen to go to after timeout) to a number from 1 to 96 using the #3 button labeled
"Default Scrn". For Main Menu set to 1.
6) Set the default menu screen timeout (seconds) using the #4 button labeled "Scrn Tout". Set to "00" to disable the timeout or a
number from 15 - 255 seconds. If a menu is selected from the keypad, it will revert back to the default menu after the menu screen
timeout. Menus selected from the schedule using "Goto Menu" will not timeout.
7) Set the display backlight timeout using the #5 button labeled "Bklt Tout". Set to "00" to keep backlight on continuously or a
number from 15 - 255 seconds to have it turn off after the selected number of seconds have elapsed since the last button press.
8) Set the Time Display Format (12 hour or 24 hour) using the #6 button labeled "TimeFrmt".
9) Select CallerID Auto Display on/off using the #7 button labeled "AutoCID".
When CallerID Auto Display is on, the menu screen automatically switches to the Caller ID display menu on incoming calls.
To function, your phone line must be equipped with Caller ID service and Caller ID must be enabled in the WinEVM Define -
Telephone field.
10) Press the bottom (#8) button to return to the Default (Main) Menu.
Press and hold the top button
to access the Setup menu.
Setup
Ver:1
Addr: 1
Default
Scrn 0
Scrn Tout:
00 sec
Bklt Tout:
00 sec
TimeFrmt
12 hour
AutoCID:
ON
<< Main
Sets Keypad Address
Sets Default Menu
Sets Menu Screen Timeout
Sets Backlight Timeout
Sets Time Display Format
Return to Main Menu
Sets Auto Display Caller ID
