JDS Uniphase SK Series, User Manual

Page: 16 / 27

10
Table 4: Pin Assignment
Pin Signal Description
1 GND power ground
2 GND power ground
3 Busy busy output: low = idle, high = switching
4 D0 data line 0 input, least significant bit (LSB)
5 Error reset error output, low = normal, high = switch mechanism position check
failed (channel position is verified when the SK switch is reset)
6 D1 data line 1
7 not connected
8 D2 data line 2
9 not connected
10 D3 data line 3
11 not connected
12 D4 data line 4
13 /Strobe Strobe input, active low: high to low pulse = read data lines and reset line;
high pulse = ignore state of data lines and /Reset line. A minimum pulse
width of 1 µs is required. This line is pulled high internally via 10 K ohm
resistor to 5 V DC.
14 D5 data line 5
15 not connected
16 D6 data line 6, most significant bit (MSB)
17 not connected
18 /Reset Reset input: low sends the switch to the reset position, high returns to
channel as specified on data lines
19 GND power ground
20 GND power ground
21 not connected
22 not connected, reserved for D7
23 P5V 5 V power in
24 P5V 5 V power in
25 not connected, reserved for 12 V supply input
26 not connected