JDS Uniphase OneExpert DSL, User Manual

Page: 39 / 120

Chapter 3 Utilities
Specifying system settings
OneExpert DSL User’s Guide
April 2014 22052280, Revision 001
23
2 From the Screen Settings menu, select Backlight .
3 Change the brightness level using the left or right arrow key.
The brightness is set.
Setting the backlight timeout
The backlight duration specifies the amount of idle time (no key presses and no line activity) to wait
before the dimming the backlight to conserve battery life.
To set the backlight duration
1 From the System Settings menu, select Screen .
2 From the Screen Settings menu, select Backlight Timeout .
3 Select a timeout.
The backlight duration is set.
Setting the power off delay
The power management settings menu allows you to select whether to automatically turn off the
unit to conserve battery life, and set the time to wait before the backlight dims (
“Setting the backlight
timeout” on page 23 ).
To set the power off delay
1 From the System Settings menu, select Power Management .
2 From the Power Management menu, select Power Off Delay .
3 Select the amount of idle time to wait before powering the unit off.
Idle time refers to no key presses and no line activity. So, if you set the power off delay to 5
minutes and then begin a 15 minute test, the unit will not power down during the test because
there is line activity.
The auto power down parameters are set.
Specifying user information
The User Information menu allows you to enter specific information related to the technician using
the OneExpert DSL. This includes the technician name, technician ID, location (city, county, state,
country, postal code, and garage), and the account ID. This information is used when synchronizing
with the StrataSync server.
NOTE:
The OneExpert DSL will not automatically power down when connected to the AC adapter.
NOTE:
A valid account ID must be entered in order to synchronize with the StrataSync server.