JDS Uniphase IP Video Test Option HST-3000, User Manual

Page: 280 / 356

Appendix A Test Results
About test results
258
HST-3000 Ethernet Testing User’s Guide
– “Error Stats results” on page 300
– “LED results” on page 303
– “Stream LED results” on page 304
– “L2 BERT Stats results” on page 305
– “Pattern Stats results” on page 307
– “Ping results” on page 307
– “Traceroute results” on page 308
– “Message results” on page 309
– “Error Stats results” on page 300
– “Event Table results” on page 309
– “Event Histogram results” on page 310
– “Time results” on page 311
– “Saving and printing results” on page 312
About test results
After you start a test, if no errors or alarms have been
detected, the Summary result category automatically displays
a large “All Summary Results OK” message. If errors are
detected, the results are displayed. To view test results in
other categories, use the left and right arrow key to browse
through the categories, or press the Display soft key, and
then select a category.
The HST provides only filtered results (except for various error
counts) when testing using the Ethernet SIM. If you want to
observe results for un-filtered traffic, you must disable the IP
filter and TCP/UDP filter (as appropriate), and set each of the
individual Ethernet filters to Don’t Care when you configure
your test.
An exception to this is MPLS encapsulated traffic. When you
enable MPLS encapsulation on your unit, the Ethernet filter is
automatically set to filter for MPLS encapsulated traffic by