ANT-5 Printout of Result Documentation
M. Hilz File: H:/TSCQ/Tac/Geraete/ANT-5/Datatransfer/ANT5_Resulttransfer.doc
Rx
CODE,0,0
AAL23C LEXC,0,0
HP-TC-AIS,0
AIS-140,0
Hierarchy Setup
FAS-45,0,0
AAL23C UU,0,0
HP-TC-
RDI,0
LOF-140,0
Hierarchy Type:,SDH
MFAS-
45,0,0
AAL23S UU,0,0
HP-TC-
ODI,0
RDI-140,0
Rate:,STM-1 Optical
CP-BIT,0,0
AAL23 TSE,0,0
LP-TC-
UNEQ,0
PLM-140,0
AU Mapping:,AU-4
P-BIT,0,0
AAL24C LEXC,0,0
LP-LTC,0
UNEQ-140,0
Interface
Setup
REI-45,0,0
AAL24C UU,0,0
LP-TC-AIS,0
TIM-140,0
Input:,Optical
FAS-1.5,0,0
AAL24S UU,0,0
LP-TC-RDI,0
LCD,0
Virtual Container Setup
CRC-1.5,0,0
AAL24 TSE,0,0
LP-TC-ODI,0
CTM,0
VC Mapping:,VC4
CRC-2,0,0
AAL-5 CRC,0,0
LSS,0
LTC,0
Payload Type,Bulk
EBIT-2,0,0
AAL-5 ABOR,0,0
OOF-45,0
VC-AIS,0
Pattern Setup
FAS-2,0,0
AAL-5 LEN,0,0
LOF-45,0
VC-RDI,0
Pattern Type:,PRBS23
FAS-8,0,0
AAL-5 LEXC,0,0
AIS-45,0
VP-AIS,0
Anomaly,Count,Ratio
FAS-34,0,0
ICMP Error,0,0
IDLE-45,0
VP-RDI,0
Stack Error,0,0
YELL-45,0
Performance Analysis (OFF)
Defect,Duration
AIC-45,0
Event Log
No.,Event,Date,Start time,Stop
time,Dur./Count
2.) Direct printout to a serial printer.
Connect a serial printer of your choice to the serial COM port of the ANT-5 (e.g. Citizen model
PN-60. Match the parameters of the printer with the ones on the ANT-5.
Open the Application Launcher screen (ALT & ESC) and go to System, Printer.
3.) Printout to a parallel printer, using a serial to parallel converter (K 1589)
Connect the serial to parallel converter between the Centronic’s connector on the printer and the
serial port (COM port) of the ANT-5. Set the same serial parameters on the ANT-5 as done
previously on the serial to parallel converter (K 1589, settings see below).
Open the application Launcher screen (ALT & ESC) and go to System, Serial Port.
