JCM GEN2U, Training Overwiev

Page: 17 / 20

Part No. 960-000192R_Rev. A © 2017 JCM American Corporation
1 7
August, 2017 JCM® Training Overview GEN2U™ Printer
Lecture Notes
SWITCH THE PAPER LOW SENSOR OFF
For Firmware versions dated 07/06/11 and later, the GEN2U Printer’s Paper
Low Sensor can be switched off and on, as needed. To do so:
1. Press the Lid Latch to open the GEN2U Printer Lid (refer to Figure 2 c on
Page 4).
2. Press the
FEED Button
three (3) times rapidly.
BEZEL LED INDICATIONS
The Bezel LED will display the following Bezel LED Indications.
Table 7 Bezel LED Indications
STATUS LED INDICATIONS
The Status LEDs will indicate the operational state of the GEN2U Printer.
Table 8 Status LED Indications
Bezel Display Status
Solid ON Printer is ready and in idle
Slow Blink Paper Low or Printer Error
Fast Blink Ticket Printing/Ticket in Chute
OFF Printer Power is OFF
Condition Ready Paper Open Fault
Powered OFF
Ready Blinking
Flushed
Paper Out
Print Head Release
Lever Up or Lid Open
Temperature Error
Voltage Error
Print Head Error
Missing Index Mark
Paper Jammed Blinking
NOTE: If the Paper Low Sensor becomes enabled, the GREEN READY LED will flash
three (3) times. If the Paper Low Sensor becomes disabled, the RED FAULT LED will
flash three (3) times.