1248003-GB_v1.1
3
Configuration of transmitter programming in the receiver.
Led R1
Led R2
Standard Programming
(default option, the receiver is always configured on pluri-channel)
The relays are activated 1st relay by channel 1 and 2nd relay by channel 2 (3rd relay
by channel 1 and 4th relay by channel 2)
Flashing Flashing
Special programming
By pressing any transmitter channel, relay 1 on the receiver will be activated
ON
OFF
By pressing any transmitter channel, relay 2 on the receiver will be activated
OFF
ON
By pressing any transmitter channel, the two relays will be activated at the same
time*
ON ON
* If working in ON/OFF activation mode, relay 1 will act as impulse and relay 2 as
ON/OFF. Therefore, on the first press relay 1 will close and open the contact and relay 2
will only close. On the second, relay 1 will close and open
the contact and relay 2 will
open.
N.B.: Each transmitter can be configured independently on the receiver.
TOTAL RESET
In programming mode, the programming button is held down and the “MR” reset jumper
is bridged for 3 secs. The receiver will issue 10 short acoustic warning signals followed by
others at a faster pace to indicate that the operation has been successful. The receiver is
now in programming mode.
After 10 seconds without programming or quickly pressing the programming button, the
receiver will exit programming mode, issuing two acoustic signals of 1 sec.
For more information please see our web site www.motion-line.com
USE OF THE RECEIVER
These receivers are designed for use as remote controls for garage doors. Their use is not
guaranteed for directly activating any other equipment different to that specified.
The manufacturer reserves the right to modify equipment specifications without prior
notice.
IMPORTANT ANNEX
Disconnect the power supply before handing the unit.
In compliance with the European Directive low-voltage electrical equipment, we hereby
inform users of the following requirements:
· For units which are permanently connected, an easily accessible circuit-breaker device
must be built into the wiring system.
· This unit must always be installed in a vertical position and firmly fixed to the structure of
the building.
· This unit must only be handled by a specialised installer, by his maintenance staff or by a
duly trained operator.
· The instruction manual for this unit must always remain in the possession of the user.
· Terminals of maximum section 3,8mm2 must be used for the power supply connections.
· Use time delayed fuses.
JCM TECHNOLOGIES, S.A.
declares herewith that the product WAVE500, WAVE500-B
complies with the relevant fundamental requirements as per Article 3 of the R&TTE
Directive 1999/5/EG, insofar as the product is used correctly.
Summary of Contents for WAVE500
Page 1: ...1248003 GB_v1 1 1...
