jcm-tech RB3 TGL868, User Manual

Page: 10 / 12

Maintenance
Leds and beeps indication table
The status of leds is shown during 5 minutes after pressing PROG button or during
the Check function. The rest of the time they are turned off.
IN1/IN2
LED Beeps Equipment Message Solution
ON
No
beeps
transmitter
Safety edge activ-
ated
---
OFF
No
beeps RB3
transmitter
Safety edge con-
nection and oper-
ating correctly
---
ON
No
beeps RB3
transmitter Connection/ Con-
figuration error
Check if safety
edge is pressed, if
not review the con-
nections and con-
figuration and
reprogram again
Intermittent
No
beeps RB3
transmitter
The safety edge
does not oper-
ates well (it is not
connected or not
programmed) Connect properly
or program the
safety edge trans-
mitter on the
receiver
OFF
4 beeps
every
20
seconds
RB3
receiver RB3 transmitter
low battery Verify the batteries
of the transmitter
ON
No
beeps RB3
receiver
Communication
failure between
RB3 R and RB3 T Verify the radio sig-
nal with the Check
function
jcm technologies
10