jcm-tech HONOARELAY, User Manual

Page: 9 / 24

Configuration
Connect to the Internet
The device must be connected to the Internet to change its settings, but it does not require a connection to function.
With the device connected to a power source, check that the ST LED is blinking green, and that the NW LED is blinking in
red. If this is not the case, hold the WPS / RST button for 10 seconds (release when the ST LED is solid green, and the NW
LED is solid red).
If you cannot find the WPS / RST button or the LED lights, see the
image on page 6.
Use your phone or computer to connect to the WIFI network HONOARELAY_0000000000. "0000000000" is in reference to
the device's serial number (found on the label on the back of the device).
Set up the HONOARELAY_0000000000 connection: the settings website will automatically appear (if not, go to
192.168.4.1 on your browser):
Select the WIFI network to connect to (the signal must be Good or Poor for optimum operation), enter the WIFI password,
and press "Save".
Wait until the three LED lights are solid green, indicating that the WIFI connection has been successfully established. This
operation may take a minute.
jcm technologies
9