![background image](http://html1.mh-extra.com/html/jcm-global/tbv-series/tbv-series_integration-manual_640267032.webp)
P/N 960-100925R_Rev. A {EDP #186705}
© 2010, Japan CashMachine Co, Limited
2 4
Transaction Based Validator Integration Guide
Red
(14)
Red
(14)
Voltage Problem
Input Voltage is too low.
[Solution] Check that the following parts are properly assembled and/or Harness
connected. Clean or adjust the following parts and Sensors.
[Relative Parts] Power Supply Unit.
If the error is not resolved, change the above related part or parts.
Red
(15)
Red
(15)
Fraud Detection
Sensors detect Banknotes remain in path, or none existed during an abnormal
timing condition.
[Solution] Check that the following parts are properly assembled and/or Harness
connected. Clean or adjust the following parts and Sensors.
[Relative Parts] Line Sensor, Feed-out Sensor, Box Feed-out Sensor, Side Sensor.
If the error is not resolved, change the above related part or parts.
Red
(16)
Red
(16)
I2C Access Error
While communicating with each device on the CPU Board, Sensors detect an
abnormal operating condition.
[Solution] Check that the following parts are properly assembled and/or Harness
connected. Clean or adjust the following parts and Sensors.
[Relative Parts] CPU Board.
If the error is not resolved, change the above related part or parts.
Red
(18)
Red
(18)
SDRAM Error
SDRAM reading and/or writing is not properly performed.
[Solution] Check that the following parts are properly assembled and/or Harness
connected. Clean or adjust the following parts and Sensors.
[Relative Parts] CPU Board.
If the error is not resolved, change the above related part or parts.
Red
(19)
Red
(19)
EEPROM Reading
Error
EEPROM reading is not properly performed.
[Solution] Check that the following parts are properly assembled and/or Harness
connected. Clean or adjust the following parts and Sensors.
[Relative Parts] CPU Board.
If the error is not resolved, change the above related part or parts.
Red
(20)
Red
(20)
EEPROM Writing
Error
EEPROM writing is not properly performed.
[Solution] Check that the following parts are properly assembled and/or Harness
connected. Clean or adjust the following parts and Sensors.
[Relative Parts] CPU Board.
If the error is not resolved, change the above related part or parts.
Red
(21)
Red
(21)
Feed Motor Over
Current Problem
While operating the Feed Motor, Sensors detect an over current condition.
[Solution] Check that the following parts are properly assembled and/or Harness
connected. Clean or adjust the following parts and Sensors.
[Relative Parts] Feed Motor.
If the error is not resolved, change the above related part or parts.
Red
(22)
Red
(22)
Stack Motor Over
Current Problem
While the Stack Motor is operating, Sensors detect an over current condition.
[Solution] Check that the following parts are properly assembled and/or Harness
connected. Clean or adjust the following parts and Sensors.
[Relative Parts] Stack Motor.
If the error is not resolved, change the above related part or parts.
Red
(23)
Red
(23)
Feed Motor
Overheat Problem
While the Feed Motor is operating, Sensors detect an overheating condition.
[Solution] Clean that the following parts are properly assembled and/or Harness
connected. Clean or adjust the following parts and Sensors.
[Relative Parts] Feed Motor.
If the error is not resolved, change the above related part or parts.
Table 21
Standard LED Error Codes (Continued)
On-line
Off-line
Error
Causes and Solutions
LED Color
(Flash
Sequence)
LED Color
(Flash
Sequence)