JCB-WP80T
Instruction & User Manual
13
Assembly
Suction Hose
Always use a commercially available hose and hose connector with the hose clamp provided with the pump. The
suction hose must be reinforced with a non-collapsible wall or braided wire construction.
Do not use a hose smaller than the pump’s suction port size. Minimum hose size: 80mm (3 inches)
*NOTE* - The suction hose should be no longer than necessary. Pump performance is best when the pump is
near the water level, and the hoses are short.
Inlet
Sealing Washer
Hose Coupler
Coupler Ring
Suction Hose
Hose Clamp
Hose Coupler (Assembled)
Hose Clamp
Suction Hose
Strainer
Hose Clamp
>
Place the Hose Coupler then Sealing Washer into the Coupler Ring. This can then be threaded onto
the Inlet.
>
The Suction Hose can now be placed over the House Coupler (ensure the Hose Clamp is already over
the Suction Hose when connecting it to the Coupler Assembly)
>
Ensure the Coupler Assembly and Hose Clamp are tight.
>
Install the Strainer on the opposite end of the Suction Hose.