21
JCB-MS-210C
Instruction & User Manual
•
When the cutting operation is completed,
move the machine head back to its upper
(home) position and release the ON/OFF
button (2).
Attention! The machine executes an upward
stroke automatically due to the return
spring, i.e. do not release the handle (1)
after completing the cut; instead allow the
machine head to move upwards slowly
whilst applying light counter pressure.
Cross cut 90° and turntable 0° - 45° (Fig.
4, 2, 1.3)
The crosscut saw can be used to make
crosscuts of 0°-45° to the left and 0° -45° to
the right in relation to the stop rail.
Attention! For bevel cuts (inclined saw head),
the moveable extention block (16a) must be
fixed in the inner position.
•
Open the set screw (16b) on the moveable
extention block (16a) and push the moveable
stop rail extention block (16a) outwards.
•
The moveable extention block (16a) must be
locked in a position far enough from the
inner position that the distance between the
extention block (16a) and the saw blade (5) is
no more than 8 mm.
•
Before making the cut, check that no
collision could occur between the extention
block (16a) and the saw blade (5).
•
Tighten the set screw (16b) again.
•
Loosen set screw (21).
•
Use the handle (1) to set the turntable (9)
to the desired angle. The pointer on the
turntable must coincide with the desired
angular extent of the scale on the base (7).
•
Re-tighten the set screw (21) to fix the
turntable (9).
•
Cut as described under section „Cross cut
90° and turntable 0°“.
Mitre cut 0°- 45° (Fig. 1, 1.3)
The crosscut saw can be used to make mitre
cuts of 0° - 45° in relation to the work face.
Important. To make miter cuts (inclined saw
head), the adjustable extention block (16a)
must be fixed at the outer position.
•
Open the set screw (16b) for the adjustable
extention block (16a) with an Allen key and
push the adjustable stop rail outwards.
•
The adjustable extention block (16a) must
be fixed far enough in front of the innermost
position that the distance between the
extention block (16a) and the saw blade (5)
amounts to a maximum of 8 mm.
•
Before making a cut, check that the extention
block (16a) and the saw blade (5) cannot
collide.
•
Secure the set screw (16b) again.
•
Move the machine head to the top position.
•
Fix the turn table (9) in the 0° position.
•
Loosen the fix screw (23) and use the
handle (2) to angle the machine head to
the left, until the bevel pointer (25) indicates
the desired angle measurement on the scale
(24).
•
Re-tighten the fixing screw (23).
•
Cut as described under section „Cross cut
90° and turntable 0°“.
