Positec Australia Pty Limited
Unit 15, 23 Narabang Way, Belrose 2085 NSW Australia
www.jcb-tools.com
Customer Helpline 1300 889 028
12. TEMPERATURE
DEPENDENT OVERLOAD
PROTECTION
When using as intended the power
tool cannot be subject to overload.
When the load is too high or the
allowable battery temperature of 75°C
is exceeded, the electronic control
switches off the power tool until
the temperature is in the optimum
temperature range again.
13. PROTECTION AGAINST
DEEP DISCHARGING
The Li-ion battery is protected against
deep discharging by the “Discharging
Protection System”. When the battery
is empty, the machine is switched off
by means of a protective circuit: When
this occurs your tool will not switch
on. Remove and recharge the battery
pack.
should always be used for
concrete and masonry. When
drilling in metal, only use HSS drill
bits in good condition. Always use
a magnetic bit holder (not
included) when using short
screwdriver bits. When screw-
driving, apply a small quantity of
liquid soap or similar to the screw
threads to ease insertion.
10. DISPOSAL OF AN
EXHAUSTED BATTERY
PACK
To preserve natural
resources, please recycle
or dispose of the battery
pack properly. This battery pack
contains Lithium batteries. Consult
your local waste authority for
information regarding available
recycling and/or disposal options.
Discharge your battery pack by
operating your drill, then remove
the battery pack from the drill
housing and cover the battery
pack connections with heavy-duty
adhesive tape to prevent short
circuit and energy discharge. Do
not attempt to open or remove any
of the components.
11. OVERLOAD
PROTECTION
When overloaded, the motor comes to
a stop.Release the on/off button, and
the machine will restart immediately.
