Positec Australia Pty Limited
Unit 15, 23 Narabang Way, Belrose 2085 NSW Australia
www.jcb-tools.com
Customer Helpline 1300 889 028
or release a jammed drill bit.
WARNING: Never change the
direction of rotation when the
chuck is rotating, wait until it has
stopped!
4. TWO-SPEED GEAR
CONTROL (See D)
The drill has a two-speed gear
control designed for drilling or
driving at LOW (mark is 1) or HIGH
(mark is 2) speeds. A slide switch is
located on top of the drill to select
either LOW or HIGH speed. When
using the drill in the LOW speed
range, the speed will decrease and
the drill will have greater power and
torque. When using the drill in the
HIGH speed range, the speed will
increase and the drill will have less
power and torque.
Gear I
Low speed range: for screw
driving or working with large drilling
diameter
Gear II
High speed range: for working with
small drilling diameter
WARNING:To prevent gear
damage, always allow the
chuck to come to a complete stop
before changing the direction of
rotation or the two-speed gear
control.
H
9
G
D
3
E
A
5
7
B
C1
4
C2
4
F
