JCB, SO53 3LE
www.JCBDIY.com
Customer Helpline 0333 0143092
at an angle of 30° to 40°. Move
the machine back and forth with
moderate pressure. In this manner,
the workpiece will not become too
hot, does not discolour and no
grooves are formed.
WARNING! Never use a
cutting disc for roughing.
3. CUTTING
WARNING!
For cutting metal,
always work with the wheel
guard for cutting.
When cutting, do not press, tilt or
oscillate the machine. Work with
moderate feed, adapted to the
material being cut.
Do not reduce the speed of running
down cutting discs by applying
sideward pressure.
The direction in which the cutting is
performed is important.
The machine must always work in
an up-grinding motion. Therefore,
never move the machine in the
other direction! Otherwise, the
danger exists of it being pushed
uncontrolled out of the cut.
ROTATING THE GEAR CASE
Before any work on the machine
itself, pull the mains plug, and
then remove the disc and guard.
The gear case can be rotated with
respect to the machine housing. In
this manner, the On/Off switch can