JCB, SO53 3LE
www.JCBDIY.com
Customer Helpline 0333 0143092
3. CUTTING
Warning!
For cutting metal,
always work with the wheel
guard for cutting.
When cutting, do not press, tilt or
oscillate the machine. Work with
moderate feed, adapted to the
material being cut.
Do not reduce the speed of
running down cutting discs by
applying sideward pressure.
The direction in which the cutting
is performed is important.
The machine must always
work in an up-grinding motion.
Therefore, never move the
machine in the other direction!
Otherwise, the danger exists of
it being pushed uncontrolled out
of the cut.
AUTO-STOP CARBON
BRUSHES
When the resin insulating tip (14)
inside the carbon brush (15) is
exposed to contact the commutator
(16), it will automatically shut off the
motor. When this occurs, both carbon
brushes should be replaced. Keep
the carbon brushes clean and free
to slip in the holders. Both carbon
brushes should be replaced at the
same time. Use only identical carbon
brushes. (See F)
F
16
14
15
