16
JCB-20MT
Instruction & User Manual
m
Do not overload the power tool.
The
power tool does the job better and safer
when used at the rate for which it was
designed.
m
Do not angle the power tool to
sand with only one edge as this can
damage the sanding pad prevent
the sandpaper fastening properly.
m
Make use of the corners and the triangular
shape of the sanding pad to sand places
that are difficult to reach.
Sawing
Hold the multi-tool by the insulated grips
when working in areas where the acces-
sory can come into contact with concealed
electrical cables. Contact with a live cable
will cause the metal parts on the tool to also
become live – risk of electric shock.
WARNING!
Check before sawing that the saw blade
is straight and undamaged, and that the
planned cut is free from nails and screws etc.
NOTE
m
Secure the workpiece with a clamp, clips
or vice.
m
Hold the multi-tool so that the saw blade
is not touching the workpiece. Start the
multi-tool and move the power switch
to position 1, and wait until the tool has
reached full power.
Scraper
m
Hold the multi-tool so that the scraper
is not touching the workpiece. Start the
multi-tool and move the power switch
to position 1, and wait until the tool has
reached full power.
m
Move the scraper at a slight angle to the
workpiece.
m
Do not overload the power tool.
Work by applying a light pressure on the
scraper. Excessive pressure can lead to
nicks and marks in the workpiece, or
overload the multi-tool.
