jcb JCB-18RS, Instructions & User'S Manual

Page: 17 / 148

16
JCB-18RS
Instruction & User Manual
Saw Blade Installation
Prior to any assembly and adjustment always
disconnect the tool from the power supply.
WARNING!
m
Select the correct saw blade for cutting the
material in question.
m
Turn the ring on the saw blade clamp until
the saw blade can be slid into saw blade
bracket slot.
m
Release ring. The ring should now
voluntarily turned back to its starting
position. If this does not happen - turn the
ring to the starting position by hand.
m
Check that the saw blade is secured
correctly in the bracket by pulling the saw
blade.
Power Switch
Before engaging the ON/OFF switch, check
that the saw blade is properly fitted in the
bracket.
WARNING!
m
To switch on the reciprocating saw press in
the switch lock and then the power switch.
m
Switch off the reciprocating saw by releasing
the power switch.
Sawing
m
Place the reciprocating saw’s pivot shoe
against the work piece at the required angle.
m
Start the reciprocating saw and hold it
against the work piece.
Do not hold the work piece with your
hands.
WARNING!
Maintenance
Switch off the tool and disconnect the power
(remove battery/unplug) before cleaning and
maintenance. This helps avoid the risk of
electric shocks and accidental starting.
WARNING!
m
Wipe the tool with a dry or damp cloth.
Do not use a wet cloth. Do not use
detergent that contains solvent or
corrosive, abrasive additives.
This risks
damaging the surfaces of the tool.
m
Clear the tool vents and the accessory
mount of dust and dirt after each use.
Do not clean ventilation holes by
inserting sharp objects in them, such
as screwdrivers and other similar
objects.
m
Stubborn contamination in areas hard to
access can be removed with compressed air
(max 3. bar).
m
Regularly check all fasteners, screws and
bolts to make sure that they are tight.
Tighten any loose screws immediately or
serious injury could occur.
Never open the tool. The tool has no
internal parts that the user can service or
repair. Never try to repair the tool yourself.
Take to an authorised service centre.
WARNING!