4-24
©2019 JBT LEKTRO, INC. All rights reserved.
October 2019
LEKTRO 88/89 SERIES - OPERATION MANUAL
4.4.10.2
HIGH-LIFT ADAPTER
The High-Lift Adapter (also referred to
as a “Highlift Adapter” mounts to the
Cradle. It is intended for use when
hangar door and/or roof beam
overhead clearances are too low for the
aircraft tail height. See the
Aircraft
Towing Procedures Manual
.
This adapter is designed to
accommodate the aircraft's dual nose
wheel tire tracks and the required NLG
Door clearance on capture and release.
It is available in either 24” / 61 cm or 27”
/ 68.6 cm widths, and may be
configured to tow specific aircraft nose
landing gear before or after being installed on the tractor.
TRACTOR MODEL
MAX. NOSE WHEEL LIFT
a
a. Typical for average nose wheel size.
CAPACITY
b
b. NLG weight.
NOTE
8800/50SDA
22” / 55.9”
10,000 lbs / 4535 kg
Hold-Down
Spring height
and radius
depends on
tire size.
8900/50SD
23 1/4” (22.25”) / 59 cm
10,000 lbs / 4535 kg
AUTHORED BY ANTHONY HERNANDEZ - (415)786-2081 - [email protected]
