32
VTX A
8
| Rigging Manual
8.8 - INSTALLING THE LASER BRACKET
The VTX A8 Array Frame includes a mounting bracket that can be used to install a laser/inclinometer in the Array frame. The Array Frame
includes front and back laser exit holes so that the light can shine through. The included laser bracket was designed to work with the
JBL VTX LZ laser unit, the third-party TEQ-SAS Lap-teq laser/inclinometer and the RECLINE laser/inclinometer units.
TOOLS REQUIRED:
A
Phillips #2
screwdriver is needed to attached the laser bracket. All necessary hardware is included with the VTX A8 AF.
STEPS:
• Use the included screws to first secure the laser unit to the laser bracket .
• Make sure the laser unit is centered in the bracket and tighten the four screws holding the unit .
• Once the laser unit has been installed, use the additional included M4 fasteners to secure the laser bracket on to the AF .
• Depending on the Array Frame orientation, the bracket can be installed facing forward or to the rear of the Array Frame .
TIPS:
• Additional laser brackets can be purchased separately.
• Make sure to select the appropriate orientation of the laser bracket before installation.
1
2
3
4
