JBL Simply Cinema DSC 1000 Owner'S Manual Download Page 10

JBL Consumer Products

250 Crossways Park Drive, Woodbury, NY 11797

Europe: 2. Route de Tours, 72500 Château du Loir, France

www.jbl.com 

©2003 JBL, Incorporated. 

JBL is a registered trademark of JBL, Incorporated.

Part No.406-000-00969

Refinements may be made on occasion to existing products without notice, but will always meet or
exceed original specifications unless otherwise stated.
Simply Cinema is a registered trademark of JBL, Incorporated. 

*Dolby and Pro Logic are trademarks of Dolby Laboratories.

DTS

®

is a registered trademark of Digital Theater Systems, Inc.

SCS 140/SCS 146 Satellite and SCS 146 Surround Back

Frequency Response (-6dB):

120Hz – 20kHz

Sensitivity (2.83V/1m):

86dB

Nominal Impedance:

4 Ohms

Recommended Amplifier Power

10 – 50 Watts RMS per Channel

Drive Units:

12mm Titanium Laminate Dome Video-shielded HF
75mm Paper Cone Video-shielded Midrange

Dimensions (H x W x D):

111mm x 81mm x 95mm (4.4" x 3.2" x 3.7")

Weight:

0.5kg (1.1lb)

SCS 140/SCS 146 Center

Frequency Response (-6dB):

120Hz – 20kHz

Sensitivity (2.83V/1m):

88dB

Nominal Impedance:

4 Ohms

Recommended Amplifier Power

10 – 50 Watts RMS per Channel

Drive Units:

12mm Titanium Laminate Dome Video-shielded HF
Dual 75mm Paper Cone Video-shielded Midrange

Dimensions (H x W x D):

83mm x 194mm x 95mm (3.3" x 7.6" x 3.7")

Weight:

0.85kg (1.88lb)

SCS 140 Active Subwoofer

Low Frequency Cut-off:

35Hz

High Frequency Cut-off:

160Hz

Built-in Power Amplifier:

100 Watts RMS

Drive Unit:

200mm Paper Cone Long Throw Driver. Bass Reflex Enclosure

Dimensions (H x W x D):

410mm x 280mm x 376mm

Weight:

12.7kg

SCS 140/SCS 146 System

Frequency Response (-6dB):

35Hz – 20kHz

O W N E R ’ S   G U I D E

P R O D U C T L I N E :  

SCS 140, SCS 146, DSC 1000 

(230V)

D E S I G N   G O A L :

Bring the thrill of live performance and movie sound to the

home environment by calling on JBL’s professional engineering leadership.

S AT E L L I T E   T Y P E :

Titanium-laminate-dome tweeter, sealed enclosure

S U B W O O F E R   T Y P E :  

Bass-reflex enclosure

P O R T   D E S I G N :  

FreeFlow™ flared

P R O F E S S I O N A L   R E F E R E N C E :

Cinema Loudspeaker Series

®

M O D E L   N U M B E R :

P R O   S O U N D  
C O M E S   H O M E

S P E C I F I C A T I O N S  

Summary of Contents for Simply Cinema DSC 1000











Reviews: