background image

02

Thank you

for purchasing JBL's Power

Series™ automotive loudspeakers. In
order that we may better serve you
should you require warranty service on
your new speakers, please retain your
original purchase receipt and return the
enclosed warranty registration card.

Important: Installation of automotive
stereo components can require extensive 
experience performing a variety of
mechanical and electrical procedures.
Although these instructions explain in a
general sense how to install Power Series
loudspeakers, they may not show the
exact installation methods for your 
particular vehicle. If you feel you lack the
tools or necessary experience, ask your
authorized JBL car-audio dealer about 
professional installation options.

Installation Warnings and Tips
• Always wear protective eyewear when 

using tools.

• Turn off all audio systems and other 

electrical devices before you start. 
Disconnect the negative (–) lead from 
your vehicle’s battery.

• Keep speakers in their package until 

final installation. When moving a 
speaker, always rest it with the cone or 
dome facing up. Never use force to 
install any speaker.

• Check clearances on both sides of a 

planned mounting surface before 
drilling any holes or installing any 
screws. Remember that the screws can 
extend behind the surface.

• At the installation sites, locate and 

make a note of all fuel lines, hydraulic 
brake lines, vacuum lines and electrical 
wiring. Use extreme caution when cut-
ting or drilling in and around these 
areas.

Caution: In some cars, fuel tanks may be
located directly beneath the rear deck.
Check for adequate speaker-basket 
clearance before considering use of 
this location!
• Before drilling for the speakers or 

cutting holes, use a utility knife to 
remove unwanted fabric or vinyl to 
keep material from snagging in a drill 
bit or saw.

• For door installations, check the 

clearance with the windows in both 
closed and open positions and verify 
that a mounted speaker will not 
interfere with the window crank or 
power-window mechanism. 

• If mounting speakers near rear-deck 

torsion bars, glove box or other 
structural elements, check for 
clearance first.

• Do not mount speakers where they 

will get wet.

Warning: Playing loud music in an auto-
mobile can permanently damage your
hearing as well as hinder your ability to
hear traffic. We recommend listening at
low levels while in your car. JBL accepts
no liability for hearing loss, bodily injury
or property damage resulting from use or
misuse of this product.

P-Series Owner's Manual  5/25/99  9:46 AM  Page 2

Summary of Contents for Power P-23t









Reviews: