If you have any questions, or need further assistance, please visit www.JBL.com.
8
First Step
- Activate remote by moving hold
switch to on position . Orange dot not visible.
Previous/Fast Reverse
Play/Pause
Power Off
Volume Down
Next/Fast Forward
Hold Switch
Volume Up
Music Browsing
Before proceeding, make sure the iPod is docked into the JBL on stage
TM*
II and the remote Hold Switch is in a
position so that the orange dot is not visible.
Turn iPod® On:
Press any button on the remote control to wake the iPod®.
Turn iPod® Off:
Press and hold the Play/Pause button for 2 seconds.
Play a Track:
Press the Play/Pause button. Note: If the iPod® is at the Main Menu,
pressing Play/Pause will cause the iPod® to start playing all of its music.
Pause a Track:
Press the Play/Pause button while a song is playing.
Skip to Next Track:
Press the Forward button.
Skip to Previous Track:
Press the Reverse button.
Fast Advance Track:
Press and hold the Forward button.
Fast Reverse Track:
Press and hold the Reverse button.
Increase Volume:
Press the Volume Up button.
Decrease Volume:
Press the Volume Down button.
Lock Remote Buttons:
Move hold button up (orange dot visible).
Mute:
Press the Volume Up and Volume Down buttons at the same time.
Photo Browsing (iPod
®
in photo browsing mode)
The JBL on stage
TM*
II remote control can be used to browse images on your iPod® Photo player. To do so, the
remote control needs to be in the Photo Mode by following two steps listed below:
1. Set the Hold switch on the JBL on stage
TM*
II Remote (orange dot visible).
2. Press and hold the Play/Pause button and at the same time and slide the Hold switch to Active (an orange dot
not visible).
The remote is ready to browse photos forward or backward by pressing the Volume Up and Volume Down buttons,
respectively. (not enabled for TV Out).
To exit Photo mode, slide the Hold switch from Active to Hold, then back to Active.
Easy Setup Guide
®
