Installation
5
1. Precautions
Choose the mounting location carefully so that the unit will not interfere with the normal
driving functions of the boat.
Avoid installing the unit where it would be subject to high temperature (such as from
direct sunlight or hot air) or where it would be subject to dust, dirt or excessive
vibration. Use only the supplied mounting hardware for a safe and secure installation.
Be sure to remove the front panel before installing the unit.
2. Mounting angle adjustment
The mounting angle of the receiver should not exceed 20 degrees from the horizontal
position.
3. Mounting example
1
2
4
Release Key
Half Cabinet
Tap
Bend these claws, if necessary.
3
<< Installation in the cabinet >>
Note
Keep the release key in a safe place as you may need it in future to remove
the unit from the boat.
145x210mm
1. POWER ON/OFF
Push the button (6) to turn on the unit. Push the button again to turn off the unit.
2. SELECT button (2)
1) Audio control ( VOLUME / BASS / TREBLE / BALANCE / FADER )
Press key quickly to select the following features;
"VOL" display - volume control > press key (2)>
"BAS" display - bass tone control >press key (2)>
"TRB" display - treble tone control > press key (2)>
"BAL" display - balance control > press key (2)>
"FAD" display - fader control > press key (2)>
Then use the spindle knob to adjust. If the key or one of the keys is not pressed within
5 seconds, the radio automatically switches into volume control mode.
These settings are indicated on the display window.
2) Beep 2nd , I-Vol , Area and DSP Selection
When the SEL button is pressed over 2 seconds, the unit will be operated as below:
a. Beep 2nd
On the Beep 2nd, you can control the Beep on or Beep 2nd by turning the spindle knob.
-
Beep on : You can hear "Beep" sound when you press all buttons.
-
Beep 2nd :You can hear "Beep" sound when you press the button over 1.5 seconds.
b. I-Vol
By pressing the button again, the unit will be into the I- VOL mode. (Initial Volume Level
Adjustment). You can adjust the I-Vol of what you want to set by turning the spindle
knob and the I-Vol will be set automatically. After the setting of initial levels, when the
unit is power on/off, detach on/off, and ACC on/off, if the present level is lower than
Initial level or if the present level is higher than initial level, it will keep the present level.
VOLUME
Select
BASS
Select
TREBLE
Select
FADER
Select
BALANCE
Select
8
Controls
Beep 2nd
I-Vol
Area
Press
Press
Press
DSP
3
2
7
4
8
18
16
10
11
12
13
14
15
6
17
1
5
9
SEL
MARINE
MARINE
PWR
MODE
MR - 6.2 / 4CH x 45Watts
2 INT
3 RPT
5
6
0.LD
BD/FN
8.DIS
7. SCN
9.
A
.P
S
REL
1
SH
SR
COMPACT DISC PLAYER
DETACHABLE SYSTEM
4 RDM
EST.JBL(MR6.2)-061129-I/B
