Important notes
4
Prior to the final installation, carry out a sound check. If high distortion or intermittent
sound is experienced, it is possible that the wiring from the CD receiver to the boat's
electrical system is poor or that the battery needs recharging.
If the battery and its charging circuit are OK, then rewire the red fused wire of the CD
player directly to the positive terminal (+) of the boat battery.
Marine accessory shops stock the connector blocks and the 10 Amp cable which may
be necessary for extending the fuse wire connection.
Grounding
Make sure that the black wire on the wiring harness is connected to a good ground
point on the boat. If the chassis of the boat is used as a grounding point, make sure
that the surface is scraped clean from the metal before attaching the wire to it.
It is preferable to connect the black ground wire directly to negative terminal (-) of the
boat battery.
Warning: polarity...
This model is only suitable for use in boats which have a negative ground system, e.g:
the negative terminal of the boat
battery is connected to the chassis.
Connecting the speakers and power cables
Before you wire your system, disconnect your boats battery's positive (+) cable.
This helps prevent damage in case of a short. When you complete the wiring,
reconnect the battery cable and test your marine stereo. When connecting your
marine stereo's black ground wire, be sure to connect the wire to a metal part of your
boat or preferably to the negative (-) terminal of the boat battery.
POSITIVE
CHASSIS
NEGATIVE
CHASSIS
145x210mm
c. Area Selection
By pressing SEL button again, the unit will be in Area Selection mode. Use the spindle
knob to choose USA or EUR (Europe). Press and hold the BAND button for 1-2
seconds to set the format.
d. DSP
Choose from flat, classic, pop or rock by pressing the SEL button again. Adjust with
spindle knob.
3.Volume control
Turn the spindle knob (2) left or right to decrease or increase the volume level.
The radio will automatically default to volume mode when powered up.
-
Bass control
Turn left to lower the bass.
Turn right to increase the bass.
-
Treble control
Turn left to lower the treble.
Turn right to increase the treble.
-
Balance control
Turn left to decrease the right speaker volume.
Turn right to increase the left speaker volume.
-
Fader control
Turn left to decrease the volume level of any loud speakers connected to the front channel.
Turn right to decrease the volume level of any loud speakers connected to the rear channel.
4."MODE" button (4)
Press this MODE button (4) to select Radio CD SIRIUS AUX-IN.
5. BD/FN button (8)
In Radio mode, press the BD/FN button (8) will shift FM/AM bands:
FM1 FM2 FM3 AM1 AM2.
In SIRIUS mode, press BD/FN button (8) to select the SSR1, SSR2 or CATEGORY.
6. SHIFT / SCROLL button (5)
SIRIUS function button only.
7. How to adjust the clock / time (17)
a.
Press and hold the DIS (17) button until the time flashes on the display.
b.
Turn spindle knob clockwise to set hour.
c.
Turn spindle knob counter clockwise to set minutes.
d.
Press the DIS button again quickly to accept the adjusted time.
If no button is pressed within 5 seconds, then it automatically accepts the adjusted
time without further intervention from the user.
8. Loudness function (7)
In order to emphasize the bass and the treble at low volume, press the LD (8) button.
To turn off loudness, press the LD button again.
9
Controls
EST.JBL(MR6.2)-061129-I/B
