1. POWER ON/OFF button, MUTE button (1)
2. SELECT button (2)
2-1 Audio control ( VOLUME / BASS / TREBLE / BALANCE / FADER )
a. BASS Control
b. TREBLE Control
With the unit off, press the Power button (1) to turn on the unit.
With the unit on, press and hold for more than 2
to turn off the unit.
If the key
or one of the keys is not pressed within 5 seconds, the radio automatically switches into
volume control mode.
To adjust the bass tone level, first select the bass mode by pressing button (2) until BASS
appears on the display panel. Press VOL +/- (16) within 5 seconds to adjust the bass level
as desired. The bass level will be shown on the display panel from a minimum of BASS -7
to a maximum of BASS +7
To adjust the treble tone level, first select the treble mode by pressing button (2) until
TREBLE appears on the display panel. Press VOL +/- (16) within 5 seconds to adjust
the treble level as desired. The treble level will be shown on the display panel from a
minimum of TREBLE -7 to a maximum of 7
A quick press of the Power button while "on" results in the MUTE function.
seconds
Press SEL button (2) repeatedly to select the desired mode in the following order:
At each feature, press VOL UP/DOWN button to adjust to the desired level.
Please note that if an EQ setting is chosen, then you will not be able to access BASS and
TREBLE functions. This is because the stereo has pre-chosen those levels for you. You
may adjust BASS and TREBLE if EQ is in the OFF position.
.
.
BASS --> TREBLE --> BALANCE --> FADER--> EQ
General Controls (In Detail)
1
5
7
9
11
13
3
2
6
8
10
12
14
4
16
15
MC-20
7
10
Radio Operation
1
5
7
9
11
13
3
2
6
8
10
12
14
4
16
15
1. Radio Operation
2. To Select Band
3. Manual / Seek tuning button (15)
4. Manual Station store
5. A.PS - Auto Store function (13)
6. Scan function (11)
7. Program Memory Scan
Press MOD button (3) to select Radio mode. Station frequency is indicated on display.
Press BD/FN button (4) to toggle through radio modes as follows:
FM1 --> FM2 --> FM3 --> AM1 --> AM2 --> FM1.
Press this button quickly to activate the Seek mode. The Seek mode will automatically
seek up or down the wave band and stop at the next station of sufficient signal strength.
Press and hold tuning button for 2 seconds to enter manual tuning mode. The unit will
revert back to Seek mode after 10 seconds without use.
Select the desired band and tune to a radio station to be memorized. Choose the preset
button memory location span 1-6 into which the station is to be stored and press and
hold that preset button for 2 seconds.
The station will now be entered into the preset memory. 6 stations can be memorized
on each of the FM1, FM2, FM3, AM1, AM2 bands.
Press and hold A.PS button for approximately 2 seconds until you hear a beep which
confirms the memory function is engaged. The unit will SEARCH for six strong stations
and automatically store them on buttons 1 - 6. (FM/AM only)
You can override the preset station on any button by manually setting a new frequency.
In Radio mode, press the SCAN button to scan strong stations. At the desired station press
the SCAN button again to stop scanning.
Momentarily press A.PS and the unit will scan for stored stations.
Momentarily press it again to stop scanning.
MC-20
