background image

C

D

( SIRIUS control )

( AUX-IN )

RE

SE

T

RM

FR

ON

T

AN

T

CD

C

 145x210mm

2

Installation Notes

Applicable to both 2 and 4-speaker connection:
  A. Connections
  B. Din cable connection for remote control 
  C. Din cable connection for SIRIUS control
  D. AUX-IN
  E. CD changer socket
  F. Antenna socket
  G. Front panel control disconnect/connect.

This radio contains four separate power amplifiers. To prevent possible damage to 
these amplifiers please ensure the following:

i) The boat chassis is not used as a loudspeaker ground(-).  
ii) Front and rear speaker connecting wires are not joined together.
iii) Any wires not used when completing a two speaker installation are fully insulated.
iv) The memory wire (yellow) is connected to a per 12V supply.
v) The power wire (red) is connected via the ignition switch of the boat.

Wiring identification

CONNECTOR

(AUTO ANT)

( BACK-UP  B+ )

FUSE

1A

( GROUND )

FUSE

( IGNITION B+ )

Blue

Yellow

Black

Red

Gray

Gray/Black

Violet

Violet/Black

( Front Right )

( Rear Right )

Green

Green/Black

White

White/Black

( Front Left )

 ( Rear Left )

10A

Red

White

Black

White

A

Red

Gray

Rear Line out

Front Line out

(ANT. socket)

F

E

(CD changer socket)

(Front Panel Control)

G

B

(Remote Control)

Important notes

   

 

Grounding 

Make sure that the black wire on the wiring harness is connected to a good ground 
point on the boat. If the chassis of the boat is used as a grounding point, make sure 
that the surface is scraped clean of paint before attaching the wire to it. 
It is preferable to connect the black ground wire directly to negative terminal (-) of 
the boat battery.    

   Warning: polarity... 

 

This model is only suitable for use in boats which have a Negative ground system, 
e. g. : the

 

negative terminal of the boat

 

battery is connected to the chassis.

   Connecting the Speakers and Power Cables

Before you wire your system, disconnect your boat battery's positive (+) cable. 
This helps prevent damage in case of a short. When you complete the wiring, 
reconnect the battery cable and test your marine stereo. When connecting your 
marine stereo's black ground wire, be sure to connect the wire to a metal part of 
your boat or preferably to the negative (-) terminal of the boat battery. 

POSITIVE
CHASSIS

NEGATIVE
CHASSIS

3

Summary of Contents for MBB-2.3

Page 1: ...o Prospec for in and out of warranty repairs It can not be serviced under warranty by other JBL service centers All products sold and serviced exclusively by Prospec Electronics Inc For service contact us 3325 South Morgans Point Road Mt Pleasant SC 29466 Tel 843 849 9037 Fax 843 849 9054 Operation Manual Model No MBB 2 3 MARINE ...

Page 2: ...ere you would like to store the channel for over 1 5 seconds to save it to memory 2 Use TUNE UP DN button to find a channel you would like to store Press the preset button where you would like to store the channel for over 1 5 seconds to save it to memory 6 To Display Song Title or Artist In SIRIUS mode press SEL until SHIFT displays then press the VOL down button to display SHIFT icon Press the S...

Page 3: ...rfere with the normal driving functions of the boat Avoid installing the unit where it would be subject to high temperature such as from direct sunlight or hot air or where it would be subject to dust dirt or excessive vibration Use only the supplied mounting hardware for a safe and secure installation 2 Mounting illustrations PLEASE NOTE This black box can be used with REM45 MC 18 and MC 19 front...

Page 4: ...ite White Black Front Left Rear Left 10A Red White Black White A Red Gray Rear Line out Front Line out ANT socket F E CD changer socket Front Panel Control G B Remote Control Important notes Grounding Make sure that the black wire on the wiring harness is connected to a good ground point on the boat If the chassis of the boat is used as a grounding point make sure that the surface is scraped clean...

Reviews: