4
Important notes
Prior to the final installation, carry out a sound check. If high distortion or intermittent
sound is experienced, it is possible that the wiring from the CD receiver to the boat's
electrical system is poor or that the battery needs recharging.
If the battery and its charging circuit are OK, then rewire the yellow fused wire of the
CD player directly to the positive terminal (+) of the boat battery.
Marine accessory shops stock the connector blocks and the 10 Amp cable that may
be necessary for extending the fuse wire connection.
Grounding
Make sure that the black wire on the wiring harness is connected to a good ground
point on the boat. If the chassis of the boat is used as a grounding point, make sure
that the surface is scraped clean of paint before attaching the wire to it.
It is preferable to connect the black ground wire directly to negative terminal (-) of
the boat battery.
Warning: polarity...
This model is only suitable for use in boats which have a Negative ground system,
e. g. : the negative terminal of the boat battery is connected to the chassis.
Connecting the Speakers and Power Cables
Before you wire your system, disconnect your boat battery's positive (+) cable.
This helps prevent damage in case of a short. When you complete the wiring,
reconnect the battery cable and test your marine stereo. When connecting your
marine stereo's black ground wire, be sure to connect the wire to a metal part of
your boat or preferably to the negative (-) terminal of the boat battery.
POSITIVE
CHASSIS
NEGATIVE
CHASSIS
9
1
. Manual/Seek tuning buttons (15):
Rotate this button quickly to activate the Seek
mode. The Seek mode will automatically seek and stop at the next station of sufficient
signal strength. Rotate and hold tuning buttons for 2 seconds to enter manual tuning
mode. The unit will revert back to Seek mode after 10 seconds without use.
2. Manual Station store:
Select the desired band and tune to a radio station or Sirius
Channel to be memorized. Choose the preset button memory location into which the
station is to be stored, then press and hold that preset button for 2 seconds. The station
will now be storeded into the preset memory. 6 stations can be memorized on each of
the FM1, FM2, FM3, AM1, AM2 on 0-6 preset buttons, and 10 channels can be
memorized on each of SSR1, SSR2 on 0-9 preset buttons.
3. A/PS - Auto store function (18)
Press and hold button (18) for approximately 2 seconds until you hear a beep which
confirms the memory function is engaged. The unit will "SEARCH" for six strong
stations and automatically store them on buttons 1 - 6.
You can override the preset station on any button by manually setting a new frequency.
4. Scan (16)
Press this key (SCAN 16) to scan strong stations for previewing. At the desired station
press the "SCAN (16)" button again to stop scanning.
5. Program Memory Scan
Momentarily press A.PS and unit will scan for stored stations.
Momentarily press it again to stop scanning.
Station Tuning
12
4
5
3
6
1
13
14
17
15
18
7
8
9
10
11
16
2
MARINE
19
MUTE
MUTE
