- CONTENTS -
BASIC SPECIFICATIONS …………….……..…………..1
SAFETY INFORMATION
…………….……..….………..2
E150P PACKING……..………………….….….….……...3
P10SW PACKING……..……………………….…………4
DETAILED SPECIFICATIONS ……….……..…………..5
CONNECTIONS………………………...……..…...…..…6
OPERATION ……..………………….……...…….….…...9
BASIC TROUBLESHOOTING..………….……………..10
E150P EXPLODED VIEW/PARTS LIST…….….……..11
P10SW EXPLODED VIEW/PARTS LIST……….……..12
TEST SET-UP AND PROCEDURE….…………………13
AMPLIFIER BLOCK DIAGRAM…………………………14
E150P BULLETIN JBL2005-01..……………..… ……..15
E150P/P10SW TECH TIP JBLTT2003-04 ..…….…...16
DETAILED TROUBLESHOOTING……………………..17
P.C.B. DRAWINGS….…………………………………….20
ELECTRICAL PARTS LIST ..……….……….……….…24
IC/TRANSISTOR PINOUTS..……..….…….….….….….28
SCHEMATICS……………………….……………………29
E150P, P10SW SPECIFICATIONS
Amplifier Power (RMS):
150 Watts
Peak Dynamic Power *:
E150P: 250 Watts
P10SW:
300
Watts
Driver:
10"
(254mm)
PolyPlas™
Inputs:
Line Level (switchable to LFE) and Speaker Level
with 5-way binding posts
Low-Pass Frequency:
Variable from 50Hz to 150Hz
Frequency Response:
27Hz – Low-pass crossover setting
Dimensions (H x W x D):
17-3/4" x 12-1/4" x 14-1/2"
(451mm x 311mm x 368mm)
Weight:
33.5
lb/15.2kg
JBL continually strives to update and improve existing products, as well as create new ones. The
specifications and details in this and related JBL publications are therefore subject to change without notice.
*
The Peak Dynamic Power is measured by recording the highest center-to-peak voltage measured across the output of
a resistive load equal to minimum impedance of the transducer, using a 50Hz sine wave burst, 3 cycles on, 17 cycles off.
1
E150P/P10SW
subwoofers
Summary of Contents for E150P
