Operation
9
Authentics L8
Operation
Turning the JBL Authentics L8 ON and OFF
to turn the JBl authentics l8 On, press the power button on
the top panel of the system.
to put the system into standby mode, again press the
power button.
NOTE: You can toggle between the Standby and the
Operational modes by pressing the Power button.
Adjusting the System’s Volume
rotate the Volume tuner on the panel of the system clockwise
to increase and counter-clockwise to decrease the volume.
the white leds around the Volume tuner indicate the volume
level of the audio system. the system has 40 steps and 12 is
the default volume level. all the voice prompts will be played
at the default level.
NOTE: When the system goes into Operational mode
from Standby, the volume set during the Operational
mode before it went to Standby becomes the default
volume level.
IMPORTANT: The lowest setting of the volume tuner
will mute the system.
Muting the System
to mute the JBl authentics system:
• set the volume to level 0 by rotating the Volume tuner
counter-clockwise.
NOTE: There are no other means to mute the audio
system.
Switching Sources
press the JBl authentics l8 source button for up to two
seconds to cycle between the sources in the following
sequence:
1. airplay
2. dlna
3. Bluetooth
4. aux Input
5. digital Optical
the system can play only one active source at a time. press
the source button whenever you want to change the source.
the system has an auto-switch function to switch sources
automatically. If you attempt to connect to another source
while the system is in operational mode with one source, the
system stops or pauses the audio from the last source.
Operating through Bluetooth
to wirelessly stream audio to the JBl authentics l8 from a
Bluetooth-enabled device:
1. confirm that the system is in the Bluetooth pairing
mode (the Bluetooth indicator led will flash white
on a regular basis). If the led does not flash
white, press and hold the source button until the
system disconnects from the other source and the
Bluetooth indicator led starts flashing white.
> 3s
