Connections
Shielded cable is necessary for all input and output connec-
tions. Make certain that the shield is properly connected, as
shown in Figures 3 and 4.
Input Connections—Inputs
to the 5233 and 5234 are for a
line level source, balanced or unbalanced. Screw terminals
on the rear panel are provided for connection of each input
and are clearly identified. Balanced connections are shown
in green; exchanging hi and lo conductors will result in phase
reversal.
Output Connections—
Each output channel can deliver 6.2 V
into 600 n or greater (+18 d B referenced to 0.775 V). A sep-
arate pair of screw terminals, located on the rear panel, is
provided for the low and high frequency outputof each channel.
Outputs will drive the line input of any conventional amplifier.
Typically, the impedance of a bridging input is at least 5 k n
(usually 10 k n or more); therefore, two or more power ampli-
fiers can be driven by a single electronic frequency dividing
network.
J
Dual Channel
5234 ELECTRONIC FREQUENCY DIVIDING NETWORK
CHANNEL 2 LO
5234
PROGRAM
SOURCE
PROGRAM
SOURCE
PROGRAM
SOURCE
F i g u r e 3.
Wiring Diagram For Br Amplification.
AMPLIFIER
AMPLIFIER
AMPLIFIER
AMPLIFIER
LOUDSPEAKER SYSTEM
CHANNEL 1
LOUDSPEAKER SYSTEM
CHANNEL 2
4
Single Channel
5233 ELECTRONIC FREQUENCY DIVIDING NETWORK
PROGRAM
SOURCE
PROGRAM
SOURCE
AMPLIFIER
AMPLIFIER
LOUDSPEAKER SYSTEM
HIGH
LOW
CHANNEL 1
HIGH
LOW
HIGH
LOW
